jimmo62
New member
Hi all
My Fenix HL60 (same as HL55 but with USB recharging) is broken - there is a thin flexible printed wiring connector which runs from the LED unit in the main body to the switch PCB and this has broken off at the LED end which is inaccessible without further disassembly. I was going to just replace it with some wires myself but I can't get the LED cover off - it looks like it's held on by 4 torx screws but a T5 is just slightly too small and a T6 is too big so I can't get it open.
Does anyone repair these? Or does anyone know where I can get a tool to open it so I can have a go?
Ta
Jim
My Fenix HL60 (same as HL55 but with USB recharging) is broken - there is a thin flexible printed wiring connector which runs from the LED unit in the main body to the switch PCB and this has broken off at the LED end which is inaccessible without further disassembly. I was going to just replace it with some wires myself but I can't get the LED cover off - it looks like it's held on by 4 torx screws but a T5 is just slightly too small and a T6 is too big so I can't get it open.
Does anyone repair these? Or does anyone know where I can get a tool to open it so I can have a go?
Ta
Jim