http://www.instructables.com/id/DIY-Wetsuit-Dryer/

Cheap and simple

One way of doing it I suppose. Could also use a bathroom extractor fan and some flexible ducting. No need to mount the fan on the hanger, just hang up the kit and then poke the ducting in to arms, legs etc as required. Mains electrickery no where near the wet kit. Perhaps a 12v fan would have been more appropriate.

And why fabricate/bend a couple of brackets when you could just as easily mount the fan diagonally on the hanger using the fans mounting holes? 


I was more impressed with the bending attachment for the vice.


Maj.

One day caving drying rooms will have hoses with small valves hanging from the ceiling. Open the valve, poke into the oversuit... voila

Incidentally this is way, way, _way_ cheaper in electrical terms than running a heater...