Premier Lamp Replacement Seal

[dougle89]

Does anyone know where I can get a replacement seal for my premier carbide lamp? It’s approx 95mm diameter. Not sure on the model but photo attached

 

[Chris Curry]

If it isn't available any more, it's fairly straightforward to custom make O-rings to a required diameter with o-ring cord such as this. The trick is to join the ends neatly - a matching cut with a very sharp blade then superglueing the cut faces together works well.

 

[Pitlamp]

I've sorted this problem in the past using homemade rings from thick inner tube (but you may need more than one).

 

[Jopo]

Does anyone know where I can get a replacement seal for my premier carbide lamp? It’s approx 95mm diameter. Not sure on the model but photo attached

If it isn't available any more, it's fairly straightforward to custom make O-rings to a required diameter with o-ring cord such as this. The trick is to join the ends neatly - a matching cut with a very sharp blade then superglueing the cut faces together works well.

Use a piece of wood with a V groove to get the cut ends perfectly aligned.