Sunset Hole, into the extension via the bypass.

DaveK

New member
I don?t normally share my trip reports here but thought this one for the UNCCs recent trip to Sunset Hole may be of interest to some people, as there isn?t much information available online about the bypass, and to an extent the extension series.

Our small group decided that due to the rain this weekend, a trip down Sunset was a safe bet, and we headed off around lunchtime.  Progress was quick with most people opting to free climb the first 2 climbs, although I rigged them to allow the option for SRT.  At the end of the second pitch we then paused to allow me to remove my SRT kit, then headed on.  We soon reached the third pitch, where I left Jacob and Joe to rig the 3rd and 4th pitches and headed back to attempt the bypass.

This was roughly were it was said to be in the description (just before the third pitch means about 15m back) and is a gully into the bedding plane on the right at head height, with an outcrop a few metres in seemingly dividing the route in 2.  What followed was an awkward crawl, with some stals and straws (nothing special in their own right but not all that common in sunset), before a series of steps down that are easily free climbed.  The final step down is into a rift passage which is for the large part too tight but can be tackled by climbing up to roof height and squeezing along the top, keeping as high as is possible.  In my opinion this is a disgusting squeeze, and I was convinced I had trapped myself a couple of times; adopting a do or die attitude as I a. was confident by this stage that this was the bypass. And b. believed I was unable to go backwards.  I was able to make it through (the squeeze is around 4m long) and was fortunate enough to find there were handholds to allow a headfirst dive back down the rift to release my legs. Once back at the bottom of the rift, a few metres saw me at the top of another couple of free climbable steps; climbing down, the passage then went back on itself and after a few more metres reached the iron bar that marks the entrance to the extension for the main chamber is reached.
At this point I sat and waited for the remainder of the group to head down the main pitch, where they then attached a ladder to the in situ tatty rope, allowing me to pull it up and rig it off a natural.  I headed down to retrieve my SRT kit and ropes for the extension.  The group split at this point, Doc, Jacob, Joe and I headed into the extension while Jen and Yasmin opted to wait in an emergency shelter for us to return.  A note here for anyone going up from the main chamber, the passage is split into 2 at the top of the iron bar, the left leads to the extension while the right leads to the bypass.

After some awkward crawling and a short drop down, we reached the first pitch in the extension, which had an abundance of naturals for rigging, and we were able to do with a 15m rope rigging off two naturals.  Embarrassingly at this point, I realised my descender had gone rogue, but not wanting to go back and search yet decided to descend on my jammers.  At the bottom, we found ourselves in a large bedding plane, with options of exploration to both the left and right (we decided not to look). Directly in front of us, a climb down through boulders led to the corkscrew, which Joe and I headed through.  At the end of the corkscrew, we found ourselves in some tight passage about 3m back from the 2nd pitch head, and with ample room in the bedding plane around the sides.  Rather than descend, we enjoyed the view from the bedding plane (it?s quite pleasant in its own way, but is just a big pit in the ground) before heading back out, with Joe having to help pull me out of the corkscrew, everyone going via the main chamber, and me managing to find my descender again in the pool at the bottom of the second pitch.  The volume of water had increased slightly whilst we were in the cave,  meaning we were pretty thankful we had left the pitches rigged!

An enjoyable trip, although I can?t say I enjoyed the bypass, as I was pretty concerned that I had got myself stuck several times.  For reference with the squeeze, I?m just shy of 6 foot and weigh around 82kg, plus I?m certainly not an expert with squeezes so may have been doing things wrong! 
 

mch

Member
Thanks for that description DaveK. I've done Sunset 3 or 4 times (quite a while ago) and have always meant to have a look at the bypass. Thanks to your efforts I don't need to bother now!
 

PeteHall

Moderator
DaveK said:
Embarrassingly at this point, I realised my descender had gone rogue
Assuming you don't have any complicated rigging to get passed, an Italian Hitch is a very handy knot in this situation (assuming you have a steel carabiner)

Got me out of an embarrassing situation after walking up the fell as a student, with two giants of the caving world who had invited me digging, only to discover that my rack was not in my tackle bag, having gone back to Durham the night before with a load of club kit...  :-[

Or on a short pitch you could take your chances with a classic abseil, though I would suggest a little practice somewhere safe (and make sure to wear gloves if the rope is gritty and muddy!)
 

DaveK

New member
I didn't think of using an Italian Hitch, that would have certainly been a lot quicker!  Although I don't intend to have a descender run away again, it's definitely a useful tip, thank you  :)
 

Ian Ball

Well-known member
Pete makes an important additional tip, don't use an alloy krab.
The NC2 warning about the Upper Series has kept me away for years, impressed you went for it.  (y)
 

Fulk

Well-known member
Well, I have on the odd occasion abseiled using an Italian Hitch and alloy karabiner with no ill effects.
 

PeteHall

Moderator
On a clean climbing rope, a short abseil on an Italian Hitch gives an alloy crab a nice polish, but on a muddy caving rope, I don't think you'd want to use an alloy crab for very long  :eek:
 

Simon Beck

Member
Thanks for sharing and good effort with the extensions.. It's a brilliant bit of caving and no Sunset experience should be complete without travelling that way.. I recall visiting them on several occasions, but only going the distance (beyond the Corkscrew) once.. I think with F-Hartley on a BCC meet, my memory of the limit was an eerily quiet inclined bouldery chamber?   
 

Fulk

Well-known member
Well, PeteHall, the furthest I've abseiled on an alloy krab/Italian Hitch was to the top of the big pitch in Aquamole Pot . . . but I fully accept your point; the entrance pitches in Aquamole are quite clean (I chickened out of the big pitch and instead pulled up someone else's descender on the end of the rope). I wouldn't want to use this technique on a muddy rope.
 

DaveK

New member
Simon Beck said:
Thanks for sharing and good effort with the extensions.. It's a brilliant bit of caving and no Sunset experience should be complete without travelling that way.. I recall visiting them on several occasions, but only going the distance (beyond the Corkscrew) once.. I think with F-Hartley on a BCC meet, my memory of the limit was an eerily quiet inclined bouldery chamber? 

That's where we got too, we decided not to descend into the pit (which also saved taking ropes and SRT kit through the corkscrew), but were still able to admire it from the bedding plane surrounding it... i found it quite peaceful, especially given the wind on the surface on Saturday!
 

aricooperdavis

Moderator
PeteHall said:
On a clean climbing rope, a short abseil on an Italian Hitch gives an alloy crab a nice polish, but on a muddy caving rope, I don't think you'd want to use an alloy crab for very long  :eek:

I abseiled maybe 25m on a pretty old muddy caving rope last year using an Italian hitch on an alloy and did some real damage to it.
 

Attachments

  • IMG_20200204_091149.jpg
    IMG_20200204_091149.jpg
    2.4 MB · Views: 276

Fjell

Well-known member
You need something more like this if you want the occasional use. My problem is how hot it all gets unless it is quite wet. A tube gets like that too if you overdo it. Not much metal on offer.
 

Attachments

  • 73725_663a.jpg
    73725_663a.jpg
    175.8 KB · Views: 266

georgenorth

Active member
Thanks for sharing and good effort with the extensions.. It's a brilliant bit of caving and no Sunset experience should be complete without travelling that way.. I recall visiting them on several occasions, but only going the distance (beyond the Corkscrew) once.. I think with F-Hartley on a BCC meet, my memory of the limit was an eerily quiet inclined bouldery chamber?
The big inclined chamber is Shake Cavern. The way on is through the choke in the floor (under the boulder with Good Luck! scratched on it). The choke seemed reasonably stable but the squeeze beyond (“Janine”) is pretty challenging. Great bit of cave.
 

topcat

Active member
Alloy krab issues must be caving specific. I spent a winter season and long Alpine season using IH and alloy krab for belaying and lots of epic abseil retreats with no issues at all.
I often use an IH on my shirt cows tail when caving and so far it shows no sign of wear.
Don't fret it.
 

Loki

Well-known member
The big inclined chamber is Shake Cavern. The way on is through the choke in the floor (under the boulder with Good Luck! scratched on it). The choke seemed reasonably stable but the squeeze beyond (“Janine”) is pretty challenging. Great bit of cave.
I second that. Went there c95, top trip. The very end sounded promising with a rumble of a stream in the distance. I remember the message on the block!
 
Top